Orbotech Symbion S36, Руководство программиста

Страница: 76 / 128

© Orbotech 2005 Symbion™ Programmer Guide 69
Draft - Confidential
TBA Compatible Inspections
The following inspections are compatible with the TBA Setup Tool.
Solder Volume , checks for sufficient solder
Solder Open , checks for open solder joints / lifted leads
Short , checks for bridges between terminals or components
A suitable TBA inspector must also be available, more
information on Inspections and Inspectors can be found in
Inspection Config
Setting up a TBA Inspection
To set up a TBA Inspection using the Setup Tool;
•
Select the component
A board is required in the machine for these steps.
•
Acquire an image of the component
•
From the
Recipe Table View
right click the Inspection to be set-up
The Recipe Editor views can be switched by clicking in the
top right of the Editor.
•
From the context menu select configure
If no context menu is available this indicates that a suitable
Inspector is not available. You can check the
Inspection Config
The TBA Setup Tool will open, for each Tab in turn;
•
Check the displayed result
•
Adjust parameters to achieve the desired result on the sample
•
Click to check the settings against the Image Library
•
Check the Performance Summary to see that the results are good
•
Choose to Update the Recipe , or both the Recipe and Library
If you do not wish to update, close the Tool with or
Cancel