Orbotech Symbion S36, Руководство программиста, Страница: 125 / 128

118 Symbion™ Programmer Guide © Orbotech 2005
Draft - Confidential
Load the Test Card
Before any check or calibration can be carried out the test card must be
loaded.
If any check is started before the test card is loaded the system will start the
procedure for loading the test card;
•
Click to open the play ground
•
Use the X and Y sliders to move the adapter such that the Test Card can
be loaded into the adapter (by opening the front doors)
Set X to minimum and Y to maximum to drive the adapter to the
front right corner of the system
•
Enter the test card width in the Board Size
For CC0103 the width is 178mm, for the older TC4797B the
width is 220mm
•
Load the Test Card into the Adapter by opening the front doors
Slide the Test Card all the way into the adapter, as far as the
stoppers. The ‘Orbotech’ marking should by in the lower left
corner.
•
Close the front doors and power the system by pressing the Green button
marked ‘ I ’ on the front panel.
•
Close the Playground by clicking on