Orbitalum RA 41 Plus, Руководство по эксплуатации

Страница: 28 / 40

7 Operation Operating instructions RA 41 Plus (H)
24
(07.08)
MT_RA 41 Plus (H)_BA_04_790046773_04.doc
orbitalum tools gmbh
7.6 Beveling the pipe (only at saw position 1)
Danger of being injured by chips flying around!
:
Never
work without the saw blade guard mounted.
X Wear protective goggles.
Danger of being injured by sharp cutting edges or electric shock!
:
Keep hands away from the tools during beveling.
:
Never
equip both saw positions with saw blade/bevel cutter simultaneously
X Wear safety gloves.
X Disconnect the mains plug before mounting or dismounting, maintenance
or adjustment and allow the machine to run a stop.
If the pipe cutter has not been used for a long time:
–
Turn the motor by 180°.
–
Switch the motor on and let it run for approx. 10 s.
This will ensure that all gear components are lubricated.
1. Adjust the bevel cutter (see section 7.3.2, p. 19).
2. Tighten the hexagon nut securing the saw blade if necessary (see
section 7.3.2, p. 19).
The pipe must not project beyond the cutter during the beveling operation,
always clamp into position 1 mm in front of the cutter.
3. Slide the pipe through the vice until it is 2 to 3 mm in front of the bevel
cutter, then clamp tight.
4. Use the pipe support (Code 790 052 301) or the pipe feeder
(Code 790 068 001) for pipes that are more than 1 m long.
5. Apply saw blade lubricant to the bevel cutter.
WARNING
Important
Important