ORB SCSI INTERNAL, Руководство пользователя

Страница: 24 / 35

!
TR
OUBLESHOO
TING
SECTION 3 TROUBLESHOOTING
If you encounter a problem while installing or using your ORB Drive, check this
Section for help.
If the information presented in this document does not help you resolve the prob-
lem, visit the Support Center on our web site: www.castlewood.com.
CAUTION! Always power off your computer and all peripher-
als before reconfiguring the SCSI bus. Electrical power
should be turned off before connecting, disconnecting any
cables or changing SCSI ID; otherwise, your drive or comput-
er equipment could be damaged.
LED Indicator Definitions
Green:
Power is present and drive has passed self-test.
Amber:
Drive is being accessed.
Red:
Error has occurred while checking the drive.
Upon Power On:
1. Steady Green
– Drive ready to accept disk.
2. Flashing Amber and then steady Green
– Disk is in and drive
ready for use.
3. Flashing amber, motor spins up and then spins down, disk
ejects and LED turns steady Green
– Disk failed startup diagnostics.
4. Flashing Red –
Drive Failure:
One flash - ROM failure
Two flashes - RAM failure
Three flashes - DRAM failure
Four flashes - Internal Bus Failure
Five flashes - Interface failure
During Operation:
1. Steady Green –
Drive ready to accept an ORB Disk
–
ORB Disk is loaded.
2. Flashing Amber –
Disk loading or unloading.
–
Disk in use.
3. Flashing Red –
Possible disk error detected during spin up.
Your disk will either be write-protected or ejected to safeguard the data.
• One flash to four flashes – Note the number of red flashes and contact
technical support.
• Five flashes – Bad power on detected. Cycle the power to your
computer system.
23