ORB SCSI INTERNAL, Руководство пользователя

Страница: 10 / 35

!
2. Connect the power cable to the drive.
The power cable has a 4-pin connector on the end of it that is shaped so that it
can only be installed one way. The slanted corners designate the top of the con-
nector.
Insert an unused 4-pin power connector from inside the computer into the rear
of the ORB drive. Make sure that the connector is inserted completely into the
drive. If there are no unused power connectors in your computer you will need a
Y-adapter, which allows you to branch two power connectors off one of your com-
puter’s power cables.
1.10 FINAL INSTALLATION CHECKS
1. Check cable connections.
Check that the SCSI interface cable is installed correctly with all 68 of the pins
on the rear of the drive inserted into the cable connector. Ensure also that the
4-pin power cable connector is completely inserted into the rear of the drive.
2. Confirm that the jumper block is installed in the correct position.
This position was determined in Section 1.7, Configuration Options.
3. Ensure that the cables connected to the other devices have not
been loosened or disconnected.
Cables running to devices other than the ORB drive may have been loosened or
disconnected during the installation process.
Replace the cover of the computer, reinsert the screws, connect any other
devices you may have disconnected from the computer, and reconnect the AC
cable.
1.11 SYSTEM SETUP
1. Orb disk insertion
Push a disk straight into the ORB drive with your finger
using an “in and down” motion to ensure that the
disk is seated.
Figure 12
Disk insertion
2. Power on your system.
The ORB drive should be detected during system startup.
CAUTION: If you insert an ORB disk in your ORB drive and
Windows asks you if you want to format the disk, be careful
how you respond. Formatting a disk with data on it will
destroy all the data.
9
INS
TA
LL
AT
ION
GUIDE