Oracle X7-2, Руководство по обслуживанию

Страница: 116 / 312

Remove the PCIe Riser From PCIe Slots 3 and 4
d.
Power on the server.
See “Power On the Server” on page 214 .
Verify that the System OK status indicator is steady on.
8. Use Oracle ILOM to clear the server PCIe riser fault.
If the PCIe riser fault message in Oracle ILOM is not cleared under Open Problems, you
must manually clear the fault in Oracle ILOM. For instructions for manually clearing a
PCIe riser fault, see the procedure "Clear Faults for Undetected Replaced or Repaired
Hardware Components" in the Oracle ILOM User's Guide for System Monitoring and
Diagnostics Firmware Release 4.0.x in the Oracle Integrated Lights Out Manager (ILOM) 4.0
Documentation Library at
http://www.oracle.com/goto/ilom/docs
.
Related Information
■
“Remove a PCIe Riser From PCIe Slot 1 or 2” on page 113
■
“Remove a PCIe Card From PCIe Slot 1 or 2” on page 122
Remove the PCIe Riser From PCIe Slots 3 and 4
Note -
This PCIe riser is actually installed in PCIe slot 3, but it supports an M.2 mezzanine and
up to two PCIe cards. The upper slot, referred to as slot 3, can be used for any supported PCIe
card, and, therefore, is optionally populated. The lower slot, referred to as slot 4, is dedicated
to the internal HBA card, and, therefore is always populated. The internal HBA card is a field
replaceable unit (FRU). For instructions for servicing the internal HBA card, see “Servicing the
Internal HBA Card and HBA Super Capacitor (FRU)” on page 169 .
1.
Prepare the server for service.
a.
Power off the server and disconnect the power cords from the power
supplies.
See “Powering Down the Server” on page 53
b.
Extend the server to the maintenance position.
See “Extend the Server to the Maintenance Position” on page 59 .
c. Attach an antistatic wrist strap to your wrist and then to a metal area on the
chassis.
116 Oracle Server X7-2 Service Manual • October 2017