Replace Oracle F160 Flash Card (Server Power-On)
Save the bracket screw, if applicable.
b.
Press down gently, but firmly, to properly seat the card in the slot.
10.
Secure the card bracket to the carrier.
Note -
If the PCIe card includes a mounting screw, do not use the mounting screw. The carrier
does not accept mounting screws.
Engage the server retention mechanism to secure the card to the carrier.
11.
Insert the carrier into the server chassis.
12.
For hot plug service actions, configure the Oracle F160 Flash Card and verify
drive availability.
■
Follow the server's service manual instructions for Oracle F160 Flash Card NVMe storage
drive configuration and identification.
■
Use appropriate software commands to return the system to an operational state:
■
Power on the Oracle F160 Flash Card as required.
■
Attach a device driver as required.
■
Re-activate mirror if manual intervention is required.
■
Re-sync mirror if manual intervention is required.
13.
At a terminal, use the
hotplug
command to ensure that the card is connected.
For example:
#
hotplug list /SYS/CMIOU0/PCIE1
[/SYS/CMIOU0/PCIE1] ENABLED
network@0 <pci.0,0> ONLINE
network@0,1 <pci.0,1> ONLINE
network@0,2 <pci.0,2> ONLINE
network@0,3 <pci.0,3> ONLINE
14.
Verify that the Fail LED is not lit and that the green Health LED is lit on the card
that you installed.
“Status Indicators” on page 13
Related Information
■
“Servicing the Oracle F160 Flash Card Using Oracle Hardware Management
Servicing the Oracle F160 Flash Card
47