Install a New Oracle F160 Flash Card (Server Power-On)
Caution -
Do not twist or turn the PCIe card as you insert it into the carrier. The card's
connector must be fully seated in the carrier's slot before you attempt to close the top cover.
Note -
If the PCIe card includes a mounting screw, do not use the mounting screw. The carrier
does not accept mounting screws.
b.
Close the top of the carrier.
The green latch should click into place. If the top is difficult to close, verify that the notch
of the card bracket or filler panel fits around the guide post.
8.
Insert the carrier into the server chassis.
9.
Return the server to service.
Refer to the server's service manual.
10.
Configure the server for the new Oracle F160 Flash Card.
Refer to the server's administration guide.
a.
If applicable, perform any required commands for your system to install the
device driver for the new Oracle F160 Flash Card.
b.
If applicable, perform any required commands for your system to recognize
the new Oracle F160 Flash Card.
c.
Verify successful installation of the Oracle F160 Flash Card through your
system's OS.
When the installation is complete, the Oracle Flash Accelerator F160 PCIe Card is visible
to your server operating system.
d.
Configure the system to maximize flash technology.
Related Information
■
“Oracle Flash Accelerator F160 PCIe Card Optimization Guidelines” on page 26
■
■
“Installation Overview” on page 29
■
“Oracle F160 Flash Card Service Overview” on page 37
Installing the Oracle F160 Flash Card
35