Opus Sideris, Руководство пользователя

Страница: 30 / 47

Sideris Printer
Instrukcja obsługi / User guide
30
• Install the work tables (11) on the protruding supports (21) on the front and back of the
equipment. The slots on the work table (11) should be placed over the supports (21) which
protrude from the device and then pressed down to lock them in place.
• Conne ct the USB cable to the socket on the back of the case (12) and to the computer.
• Connect the power supply to the socket on the back of the housing ( 14 ) and to the wall
socket.
• For safety of the user and the device, use only a dedicated power supply .
7. OPERATION
• Switch on the equipment with the switch ( 13 ). The display (1) will turn on, which will show
the currently measured head temperature, the heater will start to heat up to the programmed
temperature. You can check this value or change it at any time by pressing the buttons (2).
The temperature can be set in the range of 80-180 °C 176 - 365 °F with a resolution of 1 °C
or 33.8 °F. Temperature units from °C to °F and vice versa can be changed by turning on the
power supply (13 ) and holding down the temperature increase button.
• Turn on the plotter with the button (10), the indicator (9) will light up red if the head temper
ature has not reached the set value or green if it has reached it. The plotter will calibrate the
position of the trolley with the head and the work table. The device is ready to work.
Each press of the control button is confirmed by a beep.
Tinsel print on a Cover
• Press the work table lock button (3), the indicator light (4) flashes red.
• Slide the work table (6) out of the device by hand enough to have access to the entire table
work area.
• Put on the document protection pad (7).