The equipment does not require lubrication or periodic maintenance. All
points requiring lubrication have been sealed in the factory. The equipment is
powder coated and baked hard. For cleaning, use none abrasive house hold
detergents, not commercial cleaning products. Do not use petroleum or solvent
based products!
• EMD Masterpress unit.
• Stand with shelf and tabletop.
• Side extension tables (2 pcs.)
• Front extension table (1 pcs.)
• Magnetic stops
• Wind on motor and shaft, wind off shaft for foil,2 mounting brackets.
• O.MASTER FRAME MP01/MPEMD with 4 stops.
• Carrier for O.MASTER FRAME MP01/MPEMD.
• Carrier for O.Single Frame MP01/MPEMD.
12 MAINTENANCE
13 SUPPLIED WITH EQUIPMENT
41
OVL
Maximum pressure exceeded.
Reduce pressure on the control panel.
Remove used foil
Remove the used foil from the roller.
ERR1
Main camshaft limit switch fault. CALL SERVICE.
ERR2
Heater plate too low. No matrix or typeface fonts,
matrix too thin.
ERR3
Temperature sensor failure: switch off and make a note
of the symbols displayed (m, M, r, R, h, H) and CALL
SERVICE.
ERR4
e, E
Lo, Lc, Ro, Rc, Uo, Uc, Do, Dc
Fa
Fs
Mechanical faults, symbols determine the source of the
error:
Encoder - CALL SERVICE
Limit switches - CALL SERVICE
Winder not connected - connect the motor or set auto
foil feed to 0
If there is a short circuit to the foil motor. CALL SERVICE .
ERR 5
Heater temperature is to high:
switch off and CALL SERVICE.
ERR 7 enc. Foil
This means that the sensor is not working properly (eg.
The sensor head is not close enought to the foil, or the
senor wheel is not turning to measure the foil)
