CONTENTS:
HEALTH & SAFETY
SYMBOLS
GENERAL INFORMATION
TRANSPORT AND STORAGE
DESCRIPTION OF EQUIPMENT
AND ACCESSORIES
INSTALLATION AND ASSEMBLY
OPERATION AND USING THE CONTROLLER
PREPARATION OF TYPEFACE FONT AND
MATRIX TEMPLATES
HOT PRINT STAMPING WITH FOILS
TRIMMING AND DIE CUTTING
POSSIBLE FAULTS AND ERRORS
MAINTENANCE
SUPPLIED WITH EQUIPMENT
ADDITIONAL ACCESSORIES
TECHNICAL DATA
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1 HEALTH & SAFETY
• Before operating the equipment, you must read the health & safety instructions, manu-
facturer’s recommendations and the operation manual.
• The user’s guide/manual should be easily available at any time for the operator.
• The equipment should be fitted to the stand supplied and placed on a strong solid
floor, to ensure safe operation.
• We recommend that you screw the base to the floor were possible.
• The equipment should be,
• protected against moisture and dust.
• must not be placed close to heating and ventilating units.
• must not be used close to flammable gases and liquids.
• must be supplied power through the original cable which must be protected against damage.
• not be used to move the equipment or to pull the plug from the socket.
• when using, do not touch the heater head - Danger Burn Hazard!
• do not use the equipment for any other purposes other than those described in the
operating instructions.
• must be supplied with power through the original cable connected to a correctly
earthed power socket.
• a power socket should be provided, in accordance with electrical and earthing regulations.
• the supply voltage should be the same as on the technical label on the back and speci-
fications in the technical data sheet. Failure to do so may result in a electrical shock or
fire and cancel the guarantee.
• Making any changes to the electrical system or power supply cable could cause
a FIRE HAZARD or electric shock plus cancel the guarantee.
• Before replacing the 8-amp fuse which protects the electrical system, remove the plug from
the power socket, which is next to the power-switch on the back of the equipment.
• It may be necessary to change a fuse on the internal power supply board contact the service
team or a qualified electrician.
• If the old fuse is burnt and the NEW fuse goes again, CALL THE SERVICE.
24
