15
24
*MEMORY *
MODES
2.
When Auto Store mode is on the Xplorer will automatically record frequency, hits, time, date, audio on/off, and DTMF on/off.
If you wish to store additional data, such as decode data, press the SHIFT and HOLD/STORE buttons at the same time after the
signal has been captured.
RECORDING EVERY / UNIQUE FREQUENCIES
The Xplorer has the ability to store EVERY frequency captured into a separate memory location with a separate time and date stamp, even if
it is a duplicate frequency. This can be useful when surveying sites over a period of time to determine exactly when an active frequency is
transmitting.
Choosing to record UNIQUE frequencies in memory will log a frequency in a separate memory with a separate time and date stamp. As that
frequency is captured again the hit counter will start logging hits. When that frequency is viewed in memory it will display the frequency in
one memory location with the number of times it was hit thereafter.
1.
Press the MODE/POWER button until *CONFIG* is displayed. Press the UP/DOWN arrow buttons until CAPTURE is dis
played.
2.
Press and hold the FNCTN button and press either the UP/DOWN arrow buttons to switch between EVERY and UNIQUE.
CLEAR MEMORY
1.
To clear all memory locations press the MODE/POWER button until *CONFIG* is displayed.
2.
Press the UP/DOWN arrow buttons until CLEAR MEMORY is displayed. Press the FNCTN button and the UP arrow button at
the same time to clear the memory.
Note: While scrolling frequencies in memory, the Xplorer will re-tune to the frequency that is indicated in memory. If that signal
is active you will be able to hear the audio..
