SNAP-LCM4 User’s Guide
7
7
Chapter 2
2: Quick Start
This section gives quick instructions for installing a generic SNAP-LCM4 controller using factory-default
settings, which are shown on page
. If you are not using the factory defaults, see the detailed instructions in
the following sections.
WHAT YOU WILL NEED
•
SNAP-LCM4 controller
•
+5 VDC power supply
•
PC with OptoControl and a free RS-232 serial port
•
RS-232 cable
•
multimeter
•
small flathead screwdriver
•
pair of wire strippers/cutters
For help with
See page
Setting jumpers:
controller address
host port
host port baud rate
boot mode
Opening the controller and configuring the serial ports
Connecting the controller to remote I/O
