2: QUICK START
SNAP-LCM4 User’s Guide
10
8.
Configure the controller using OptoControl.
–
In order to be useful with a SNAP-LCM4 controller, a PC must have at least one element of
Opto 22’s FactoryFloor software suite installed: OptoControl, OptoDisplay, OptoServer, or
OptoTerm.
–
This guide assumes that you will configure the controller using OptoControl. For instructions,
see the
OptoControl User’s Guide
(Opto 22 Form number 724).
–
Cycle power to the SNAP-LCM4 by flipping the power supply’s power switch off, waiting 10
seconds, then turning it on again. Any change to configuration jumpers will only take place
after power is cycled.
9.
Verify communications by using the OptoTerm utility included with FactoryFloor.
a.
Choose Start > Programs > Opto22 > OptoUtilities > OptoTerm.
b.
In the OptoTerm main window, double-click the controller’s name in the list.
c.
Look for a window displaying information about the controller.
d.
If the window does not appear, make sure you cycled power to the controller after any change. If it
still doesn’t appear, check wiring connections and jumper settings.
Your SNAP-LCM4 controller is now ready to run OptoControl strategies.
