OPTO 22 G4LC32, Руководство пользователя

Страница: 24 / 50

G4LC32 User’s Guide
Running from RAM or Flash EPROM
The next display shows the current programming source to run from on power up.
RAM - ROM SELECT
RUN FROM ROM
Your choices are:
RUN FROM RAM
RUN FROM ROM
Application programs are downloaded from your PC workstation to battery backed up RAM in the G4LC32 with the
Cyrano Debugger. The factory default setting is for programs to RUN from RAM. Select RUN from RAM to make
the controller run the program found in RAM on power up. RUN FROM ROM causes the controller to use the
program in the Flash EPROM. (The AUTOBOOT/NONAUTOBOOT option determines when the program actually
starts executing.) To load your application into Flash EPROM, use the “Burn Strategy Into Flash” command found in
the Debugger’s “Controller” Top Menu Bar.
RUN FROM ROM allows you to run your application program from the Flash EPROMs. Upon power up (or RESET)
the program in Flash EPROM is moved to RAM where it is executed.
Press the left/right arrow keys to make your selection and then the
ENTER
key to accept the change.
Saving Changes
The next display asks if you want to save the changes you have made to the front panel’s EEPROM memory.
SAVE NEW PARAMETERS?
PRESS ENTER TO SAVE
ANYTHING TO QUIT
Press the
ENTER
key if you want to save the new parameters. Pressing any other key will not save your changes. In
either case, this will terminate the SETUP MODE and you will be returned to your beginning display. The EEPROM
has an expected life of 10,000 writes.
Activating Front Panel Setup Changes: Power down, then power up the controller to
activate the changes made.
CONFIGURATION
3-10