OPTO 22 G4LC32, Руководство пользователя

Страница: 19 / 50

G4LC32 User’s Guide
To enter the SETUP MODE, press the SETUP key on the keyboard. You will get the following display:
SETUP MODE:
<ESC> TO EXIT
<REQ> TO VIEW
<ENTER> TO CHANGE
If you do not wish to VIEW or CHANGE, then press the ESC key on the keyboard. You will be returned to the initial
display, and the SETUP MODE will be terminated. For security reasons, the SETUP MODE has a time-out function.
If there is no keyboard activity for approximately 3 minutes, then the SETUP MODE is also terminated. Pressing the
REQ key puts you in the VIEW MODE. Pressing the ENTER key puts you in the CHANGE MODE.
View Mode
From this mode you can display all of the G4LC32 setup parameters. The first display that you get when you enter
the VIEW MODE will be similar to the following:
VIEW MODE:
HOST PORT: COM1
PROTOCOL: BINARY
PROCESSOR ADDR: 1
The above parameters will vary depending upon how your G4LC32 has been configured. The HOST PORT is the port
on the G4LC32 used to communicate with a remote PC running Cyrano 200 or OptoControl. The factory default
setting for HOST PORT is COM0.
The PROCESSOR ADDR is the address assigned to the G4LC32. The factory default address is 1.
Press ENTER to continue viewing the setup parameters. The next display will be similar to the following:
COM0: 38.4 K
COM1: 115.2 K
COM2: 115.2 K
COM3: 115.2 K
The above parameters will vary depending upon how your G4LC32 has been configured.
Press ENTER to view the next display. The next display will be similar to the following:
PROCESSOR IS IN
NONAUTOBOOT MODE
PROCESSOR WILL
RUN FROM RAM
The above parameters will vary depending upon how your G4LC32 has been configured. The factory default for the
Autoboot Option is NONAUTOBOOT and the processor to RUN FROM RAM.
Press ENTER to view the next display.
PROCESSOR WILL
BOOT TO - KERNEL
CONFIGURATION
3-5