OPTIMUM
M A S C H I N E N - G E R M A N Y
Unpacking and connecting
Version 1.1.5 dated 2015-08-31
Page 24
Original operating instructions
BF30Vario
GB
WARNING!
Risk by using improper tool holders or operating them at inadmissible speeds.
Only use the tool holders (e.g. drill chuck) which were delivered with the machine or
which are offered as optional equipment by OPTIMUM.
Only use tool holders in the intended admissible speed range.
It is only allowed to modify tool holding fixtures in compliance with the
recommendations of
OPTIMUM or the manufacturer of the clamping device.
WARNING!
When first commissioning the drilling-milling machine by inexperienced staff you
endanger people and the machine.
We do not take any liability for damages caused by incorrectly performed commission-
ing.
"Qualification of personnel“ on page 10
3.5.1 Power supply
CAUTION!
Lay the connection cable of the machine so that a stumble of persons is prevented.
Connect the electrical supply cable.
Check the fusing (fuse) of your electrical supply according to the technical instructions
regarding the total connected power of the drilling-milling machine.
3.5.2 Cleaning and lubricating
Remove the anti-corrosive agents on the drilling-milling machine which had been applied
for transportation and storage. Therefore, we recommend you to use paraffin.
Do not use any solvents, cellulose thinner or any other cleaning agents which might affect
the coating of the drilling-milling machine when cleaning the machine. Observe the indica-
tions and notes of the manufacturer for cleaning agents.
Oil all blank machine parts using an acid-free lubricating oil.
Lubricate the drilling-milling machine according to the lubricating plan.
"Inspection and maintenance“ on page 38
Check if all spindles are running smoothly. The spindle nuts are re-adjustable.
Disassemble the V-ledges of the cross table and clean the ledges from the anti-corrosive
agent.
3.5.3 Filling in gear oil
The drilling-milling machine is delivered without oil filling. Fill in gear oil.
