Optimum 3338135, Руководство по эксплуатации

Страница: 30 / 71

Version 1.0.4 - 2020-07-28 30 Translation of original instruction
MH22V │ MH22VD EN
MH
22
V_MH2
2
VD_G
B_4.
fm
4.7.2 Gear stage

Changing the gear stage may only be at a standstill.
4.8 Direction of spindle rotation
A change in the direction of rotation at the MH22V is only possible if the spindle rotates even in
its standard direction of rotation. The standard direction of rotation is clockwise.
4.9 Feed
with the hand cranks on the milling table.
Note the different forces acting during synchronous milling and conventional milling on the spin-
dles of the milling table. The cutting forces during synchronous milling tend to be that the tool
will move into the material.
Conventional milling is always to be preferred over synchronous milling.
Only with recirculating ball screws can the use of synchronous milling be undertaken sensibly.
This instruction manual assumes that the milling machine has been obtained without recirculat-
ing ball screws.
The forces and backlash occurring in the spindle nuts leads to "chatter marks" on the surface of
the work piece in synchronous milling.
In conventional milling, the work piece moves with the hand cranks on the milling table opposite
to the direction of rotation of the milling machine.
In synchronous milling, the work piece moves with the hand cranks on the milling table in the
direction of rotation of the milling machine. A smoother surface is obtained compared with con-
ventional milling. So, machining in synchronous milling should only be used for finishing.
4.10 Spindle quill feed
With the fine feed ( 12 ).

Turn the handle screw ( 11 ) to engage the coupling of the fine feed.
Img.4-1: Fine feed
11
12