Optimum 3338131, Руководство по эксплуатации

Страница: 27 / 72

Version 2.5.1 - 2020-07-28 27 Translation of original instructions
MH20V | MH20VL | MH20VLD GB
MH
20
V_G
B
_3
.f
m
3.7 First commissioning

"Qualification“ on page 11
WARNING!
First commissioning may only take place after proper installation.
First commissioned of the milling machine by inexperienced personnel or inexperienced
users constitute a risk to personnel and equipment. We do not accept any liability for
damages caused by incorrectly performed commissioning.
ATTENTION!
Before commissioning the machine, all bolts, fastenings and protections must be
checked and retightened as necessary!
WARNING!
The use of improper tool holders or their operation at inadmissible speeds constitutes a
hazard.
Only use the tool holders (e.g. drill chuck) which were delivered with the machine or
which are offered as optional equipment by OPTIMUM.
Only use tool holders in the intended admissible speed range.
Tool holders may only be modified in compliance with the recommendation of OPTIMUM
or the clamping device manufacturer.
3.8 Electrical connection
CAUTION!
Arrange the machine's connection cable in such a way that it will not cause a tripping
hazard.
Please verify if the type of current, voltage and protection fuse correspond to the values speci-
fied. A protective earth ground wire connection must be available.

Main Fuse 16A.
3.9 Cleaning and lubrication

Remove the anti-corrosive agents which has been applied to the milling machine for trans-
port and storage. We recommend you use paraffin for this purpose.

To clean the milling machine, do not use any solvents, nitro-cellulose thinner or other clean-
ing agents that could damage the paintwork. Observe the cleaning agent manufacturer's
information and notes.

Grease all exposed machine parts using an acid-free lubricating oil.

Lubricate the milling machine in accordance with the lubrication schedule.

"Inspection
and maintenance“ on page 38

Check that all spindles are running smoothly. All spindle nuts are re-adjustable.
INFORMATION
The milling machine has been painted with varnish . This fact must be taken into account when
selecting your cooling lubricant. Optimum Maschinen Germany GmbH does not accept any lia-
bility for subsequent damages due to unsuitable cooling lubricants. The flashpoint of the emul-
sion must be higher than 140°C. When using non-water-miscible cooling lubricants (oil content
> 15%) with a flashpoint, ignitable aerosol air mixtures might develop. There is a potential dan-
ger of explosion.