Optimum 3336090, Руководство по эксплуатации

Страница: 36 / 110

Operation
Version 1.0.4 - 2020-08-04 36 Translation of original instruction
MT60 EN
MT
60_GB
_4.
fm
4.10.4 Switching the feed

Set the feed rate.

Set the selection lever for the table feed into the position .
Img.4-9: Selector lever

Loosen clamping lever on the cross table.

Set the position of the mechanical end stops.

Turn the direction lever for table feed motion (X axis) to the required feed direction.

In order to switch off the rapid traverse, turn the direction lever for table feed motion to the
neutral position.
4.11 Moving the cross table forward / back (Y axis)

Loosen the clamping lever.

Engage the hand crank by pressing into the coupling.

Position the milling table on desired position using the crank.

Clamp again if required.
~ 50Hz
A B
M L M L
mm/min I
32 48 180 275
mm/min II
80 120 460 700
inch/min I
1
1/2
2
1/2
9 13
1/2
inch/min II
4 6 23 35
3
1
2
3
"Rapid traverse" position
Neutral position
"Milling feed" position
Selection lever
1
2
3