Optimum 3336090, Руководство по эксплуатации, Страница: 17 / 110

Safety
Version 1.0.4 - 2020-08-04 17 Translation of original instruction
MT60 EN
MT
60_GB
_1.
fm
The inspection prior to initial commissioning is not required if the operator receives confirma-
tion from the manufacturer or installer that the electrical systems and operating equipment com-
ply with the accident prevention regulations, see conformity declaration.
Permanently installed electrical systems and operating equipment are considered constantly
monitored if they are continually serviced by qualified electricians and inspected by means of
measurements in the scope of operation (e.g. monitoring the insulation resistance).
1.19 Inspection deadlines
Define and document the inspection deadlines for the machine in accordance with § 3 of the
Factory Safety Act and perform an operational risk analysis in accordance with § 6 of the Work
Safety Act. Also use the inspection intervals in the maintenance section as reference values.
1.20 Clamping devices for workpieces and tools
ATTENTION!
Attention when taking over existing clamping devices. Pleased thoroughly check that the
clamping device is appropriate for your milling machine.

Only use clamping devices with a complete inherent rigidity.

Contact the manufacturer of the clamping device regarding the reuse of clamping
devices after damage to the clamping device due to collisions.

Correctly insert the workpiece and make sure that the machine is proper working
condition.
1.21 Environmental protection and water conservation
The milling machine is a device to produce, handle and use materials which are hazardous to
water according to para. 19g of the Water Resources Law.
Please follow the requirements of the Water Resources Law when operating, decommissioning
or disassembling the milling machine or parts hereof. Detailed information regarding this can be
found in the Ordinance on Installations for the Handling of Substances Hazardous to Water
(VAwS).