Safety
Version 1.0.1 - 2021-1-28
21
Translation of original instruction
GB305D
EN
GB30
5D_GB
.f
m
WARNING!
Severe injuries due to non-intended use.
It is forbidden to make any modifications or alternations to the operating parameters
values of the disc sander. They could pose an accident hazard to persons and cause
damage to the disc sander.
ATTENTION!
If the disc sander is not used as intended or if the safety directives or the operating
instructions are ignored the liability of the manufacturer for any damages to personnel
or objects resulting hereof is excluded and the claim under guarantee is becoming null
and void!
1.3
Reasonably foreseeable misuse
Any other use other than that specified under "Intended use" or any use beyond the described
use shall be deemed as non-intended use and is not permissible.
Any other use has to be discussed with the manufacturer.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning.
Operators must be qualified.
1.3.1 Avoiding misuse
The direction of rotation of the disc sander must be counterclockwise. If the phase
sequence is not used correctly, it is possible to operate the disc sander in the wrong direc-
tion of rotation.
Pay attention to the current direction of rotation of the disc sander to prevent the spin-up of
workpieces at the start of grinding. The unsuitable working area is covered by a plate for the
intended direction of rotation in the delivery condition.
We expressly point out that the guarantee will expire, if any constructive, technical or proce-
dural changes are not performed by the company Optimum Maschinen Germany GmbH.
WARNING!
Risk of injury caused by flying workpieces. Injuries caused by sharp-edged workpieces.
Injuries caused by hot workpieces. Wear protective gloves and goggles. For certain
materials it may be necessary to wear face protection instead of safety glasses.
Ensure that the support surface for the workpiece is set at the correct angle and firmly clamped.
1.4
Dangers that can be caused by the disc sander
The disc sander was built using state-of-the-art technology. Nevertheless, there is a residual
risk, as the disc sander operates with
high speeds,
rotating parts,
an grinding disc,
electrical voltage and currents.
We have used design and safety engineering to minimize the health risk to personnel resulting
from these hazards.
If the disc sander is used and maintained by personnel who are not duly qualified, there may be
a risk resulting from its incorrect or unsuitable maintenance.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
