Safety
Version 1.0.1 - 2021-1-28
22
Translation of original instruction
GB305D
EN
GB30
5D_GB
.f
m
be duly qualified,
and strictly follow these operating instructions.
Always disconnect the disc sander from the electrical power supply before performing cleaning
or maintenance tasks.
CAUTION!
The disc sander may only be operated with the work surface clamped. Operation with a
dismantled or unclamped work surface can lead to dangerous conditions for the
operator.
Disconnect the disc sander immediately, whenever you detect a failure in the safety
devices or when they are not fitted!
All additional devices installed by the operator must be equipped with the stipulated
safety devices. This is your responsibility as the operator!
1.5
Personnel qualification
1.5.1 Target group
This manual is addressed to
the operating companies,
the operators,
the maintenance personnel.
Consequently, the warning notes refer both to the use of the disc sander and to its mainte-
nance.
Always disconnect the disc sander from the electrical power supply. This will prevent it from
being used by unauthorized persons.
The qualifications of the personnel for the different tasks are mentioned below:
Operator
The user must have been instructed by the operator about the assigned tasks and possible
risks in case of improper behaviour. The user may only carry out tasks that exceed normal
operation if this is stated in these instructions and the operator has explicitly entrusted him with
the task.
Qualified electrician
With professional training, knowledge and experience as well as knowledge of respective
standards and regulations, qualified electricians are able to perform work on the electrical sys-
tem and recognise and avoid any possible dangers.
Qualified electricians have been specially trained for the working environment, in which they are
working and know the relevant standards and regulations.
Qualified personnel
Due to their professional training, knowledge and experience as well as knowledge of relevant
regulations, qualified personnel are able to perform the assigned tasks and to independently
recognise and avoid any possible dangers.
Instructed person
Instructed persons were instructed by the operating company regarding the assigned tasks and
any possible risks of improper behaviour.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
