opticis IPKVM-500-ED, Руководство пользователя

Страница: 9 / 26

- 9 -
♦ Link LED (Green)
If the green LED turns on at TX and RX, it is ready to operate as IPKVM Extenders.
9. SW & Factory Reset
♦ SW Reset: Press the Reset switch on the back of devices shortly to reset
♦ Factory Reset: To recover the Factory setting, press and hold the Reset switch on the back of
devices until the LED is turned off after blinking (approx.5sec).
▶ DHCP IP mode
▶ default values on device setup & system configuration
▶ default values on HDMI EDID
10. Connection
Important: Please keep the installation procedure below. Improper or no operation may result if the
start-up sequence is not followed correctly.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Turn on the PC, display, and network server
Step 3
Connect HDMI IN port in IPKVM-500-E (TX) to the PC by supplied HDMI cable.
Step 4
Connect mini USB port in IPKVM-500-E (TX) to USB port in PC with supplied USB cable.
Step 5
Connect Local Display port in IPKVM-500-E (TX) to local HDMI display by HDMI cable.
Then, connect the local Keyboard and Mouse to two (2) USB ports using USB hub. You may
skip Step 5 if you don’t need local control.
Step 6
Connect LAN port (RJ-45) in IPKVM-500-E (TX) to LAN port in Network server with LAN cable.
Step 7
Connect HDMI OUT port in IPKVM-500-D (RX) to remote HDMI display by supplied HDMI
cable. Then, attach keyboard and mouse for remote control.
Step 8
Connect LAN port (RJ-45) in IPKVM-500-D (RX) to LAN port in Network server with LAN cable.
Step 9
Plug the +5V power adaptors to both IPKVM-500-E (TX) and IPKVM-500-D (RX).
Note: If you change an input source to another source, you have to reset the power of all TXs
and RXs by re-plugging of the +5V power adaptor.