opticis IPKVM-500-ED, Руководство пользователя

Страница: 13 / 26

- 13 -
(1) Select one between 50MHz~Best
(2) Click ‘Save & Reboot’ to save and apply to TXs (All hosts is recommended).
♦ ODS on/off
(1) Select on or off.
(2) Click
‘Sync’ to save and apply to RXs. (Client All or selected client)
* For details, please refer to Page 19 to figure out OSD mode.
♦ Blocking
(1) Select enable or disable.
(2) Click
‘Sync’ to save and apply to RXs. (Host & Client All is recommended)
* Blocking function is to give user an authority on a host which you already occupied on a
client and then, other user cannot access the host. If user set
blocking ‘enabled’ mode, only
one client can access to one host and control a source of the host (1:1 unicast mode).
If user set
blocking ‘disabled’ (default) mode, one audio/video source of a host can be
transmitted to display monitors of many clients and controlled with keyboard and mouse on
the network (1:N multicast mode, default).
For details, please refer to Page 18, Multicast streaming and blocking function.
- Available: These TXs are ready to connect with this receiver.
- Currently connected: The RX is already connected to TX.
- Not available, in use (Red color): these TXs are already connected to other RXs. This
status message will be shown
with blocking function ‘disabled’ only.
♦ Jumbo frame
Please set ‘Disable’, if L2/L3 network switch does not operate well with Jumbo frame ‘Enable’.
♦ Network Interface Selection
Please set Ethernet or WiFi, if there are some problems with device searching.
6) EDID read/write
♦ EDID read from a client (RX)
(1) Select one of a client (RX) on the list. Connect a display to HDMI OUT receptacle of the
selected RX over HDMI cable.
(2) Click
‘EDID Read’ button. Then, you can see the saved EDID data as below.
* If the RX isn
’t connected with display monitor, you can see ‘Fail’ message.