6212C Manual Version 15_22 Rev 07-19.docx
Page 49 of 53
@22,xx,vvv#<cr-lf> Set/Query Configuration Values
Set Values
xx = subfunction
vvv = subfunction value
xx subfunction
vvv
Default
Sub Command details:
01,LIMIT_LOW, set min roughness
value
2
LIMIT_LOW, set min roughness value for failed part
output
02,Laser Settling
18
Laser Settling 55.56uS Steps
03,Head Mux Settling
2
Ext. Mux Settling 55.56us per step
04,Number of ON sweeps
2
Number of ON sweeps
05,Number of OFF sweeps
2
Number of OFF sweeps
06,First Detector in Rough Specular
Sum
4 First Detector in Rough Specular Sum
07,Last Detector in Rough Specular
Sum
8 Last Detector in Rough Specular Sum
08,First Dectector in Rough Ra
Calculation
9 First Detector in Rough Ra Calculation
09,Last Detector in Rough Ra
Calculation
32 Last Detector in Rough Ra Calculation
10,First Detector in Smooth Specular
Sum
2 First Detector in Smooth Specular Sum
11,Last Detector in Smooth Specular
Sum
2 Last Detector in Smooth Specular Sum
12,First Detector in Smooth Ra
Calculation
3 First Detector in Smooth Ra Calculation
13,Last Detector in Smooth Ra
Calculation
26 Last Detector in Smooth Ra Calculation
14,AD Mux Settling Time
2 Internal A/D Delay Loop Count 10 us per step
15,Head Type,5872, 6212, 8826
6212 Head Type Assigns # Detectors in Ra Calculation,
0=5872, 1=6212, 2=8826
16,LIMIT_HIGH, set max roughness
value
10
LIMIT_HIGH, set max roughness value for failed part
output
17,Latch Relay Duration
1
Latch Relay Duration for failed part output (1 - 100,
each # is 10 ms. A value of 10 = 100 ms)
18.Peak Percent Fine Alignment Value
(2 digit percent)
10
Percent comparison fine alignment test values for
voltages either side of peak voltage
19.Failed Part Output / Fine Align
Output Toggle
1
Toggles output trigger (pin 5 of PIC processor)
between Failed Part (default 1) or Fine Align obtained
(2)
20,Low Voltage Threshold, two digit
precision - xx.xx
0
Sets Sum Voltage Threshold Check
Query Values
A request of @22#<cr-lf> will give a response that includes all sub-commands
