6212C Manual Version 15_22 Rev 07-19.docx
Page 16 of 53
Numerous Continuous Measurements
Lasercheck Head Mounted over Large Surfaces for Continuous Automated Inspection
There are ten drilled and tapped holes on the Lasercheck sensor head that can be used for mounting and
installing the Lasercheck in a continuous automated inspection application. The head should be positioned at a
location where surface will be at the correct vertical and horizontal position relative to the gage head (see
appendix section on Lasercheck Alignment Principles and Procedures). Either the surface will move under the
gage or the gage will be moved over the surface. In either case, alignment must be maintained during relative
motion. An air knife can be used prior to the gage to clean coolant etc. from surfaces to be inspected if
necessary. “Start” and “Stop”
sensors or inputs should be positioned to be activated when the gage is positioned
to measure at the start of the process and at the stop of the process.
Trigger Sensors
Rotation
Lasercheck Sensor
Surface Direction
Air Knife
Lasercheck Sensor Mounted on Large Rotating Roll for Automated Continuous Inspection
Surface Direction
Trigger Sensors
Lasercheck Sensor
Air Knife
Large Continuous Flat Surface
Lasercheck Sensor Mounted on Large Flat Sheet for Automated Continuous Inspection
