- 4 -
- 5 -
a
d
c
b
INSTALLATION AND ANGLE ADJUSTMENT
3
Auto
P Auto Learning
The area automatically learnt by the sensor within the boundary
defined by the rough alignment rotary switches and fine
adjustment potentiometers.
P2 Auto Tracing
The area automatically learnt by tracing a person walking a
boundary within the area set by the rough alignment rotary
switches and fine adjustment potentiometers.
-Vertical Detection Area
Manual
Vertical Detection Area is not available in Manual mode.
Turn on the Auto mode to use it.
Auto
P Fix
The area being automatically recognized by the sensor scanner
within the fan-like area set by the rough alignment rotary
switches and the fine adjustment potentiometers.
P2 Refresh
The area being detected is automatically adapted every hour to
compensate for objects blocking the areas.
3- INSTALLING TO WALL AND ANGLE ADJUSTMENT
Remove the cover from the main unit.
2
Remove the mounting bracket from the main unit.
3
Attach the paper template (an accessory) onto the wall, and
drill 4 mounting holes in it. Drill 2 wiring holes as required.
Insert the anchor bolt (an accessory) into the board
mounting holes.
4
Fix the mounting bracket on the wall. Adjust the angle so
that the inclination in the horizontal plane becomes parallel
to the ground.
Cautions>>
When installing the product to the wall, fix the mounting
bracket parallel to the ground. If the mounting bracket is
set at an angle, the laser beam will not be emitted parallel
to the ground, which may result in the non-detection of
an intruder. An inclination of degree varies the shape
of the detection area of 30 m (Approx. 00 ft.) ahead by
approximately 0.5 m (.6 ft.).
Auto P (Auto Learning)
Auto P2 (Auto Tracing)
Manual
Area
A2
Area
A
Area
B
Area
B2
30 m maximum (Approx. 00 ft.)
Auto P (Fix)
Installation
height
Ground
surface
1
Loosen 2 lock screws.
Main unit fall-
protection stopper
(Washer without rubber)
1
Loosen 4 lock screws.
2
Move the
mounting
bracket
3
Remove the mounting bracket by moving it
over the stopper while opening the bottom
of the mounting bracket slightly outward.
They are not
used
A
Mounting hole in 4 locations
Diameter 6 mm (0.24 inches)
Depth
60 mm (2.36 inches)
Set the lower end of the
paper template at a position
at least 0.7 m (28 in.) above
the ground.
Wiring hole
Tighten 4 lock screws for the mounting bracket (accessories).
Adjust the angle along the slot while setting screw
hole A at the center. After the adjustment, tighten
the screws.
Angle adjustment
screws a and b
Main unit mounting
screws c and d
Area A
Area B
2
Remove the cover.
(Washer with rubber)
