Optal 4 Glass 2 burners, Руководство по установке и эксплуатации

Страница: 138 / 166

DRAFT
© 2008 Mertik Maxitrol GmbH & Co. KG,
All Rights Reserved.
1 / 2
GV60 Remote Electronic Ignition and Control System
External Source Operation
R
OPERATING INSTRUCTIONS - FOR OEM USE ONLY
Fire or explosion hazard. Attempted disassembly or
repair of controls can cause property damage, severe
injury or death. Do not disassemble the gas valve; it
contains no serviceable components.
Read these instructions carefully. Failure to follow them
could result in a fi re or explosion causing property
damage, personal injury, or loss of life. The product
must be installed and operated according to all local
regulations.
BEFORE OPERATING verify that no gas is in the area
around the appliance, including near the floo r.
WHAT TO DO IF YOU SMELL GAS:
Do not light any appliance.
Do not touch any electrical switch; do not use any
phone in your building.
Immediately call the gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
If you cannot reach the gas supplier, call the fire
department.
Use only your hand to push in or turn the gas control
knobs. Never use tools. If a knob will not push in or turn
by hand, don’t try to repair it, call a qualified service
technician. Force or attempted repair may result in a
fire or explosion.
Do not use this control or any gas appliance if any
part has been under water or in contact with water.
Immediately call a qualified service technician to replace
the control system and any gas control system which has
been under water or in contact with water.
■
■
■
■
It is the appliance manufacturer‘s responsibility to fully
disclose any operation from a remote source that will
create an unsafe operating condition. For Europe see
GADAC guidance sheet B12.
OPERATING INSTRUCTIONS
SEQUENCE OF OPERATION
(see figure 1)
To start Ignition, close contacts 1 and 3 simultaneously
for 1 second.
To set the valve to High Fire, close contact 1.
To set the valve to Pilot, close contact 3.
In each case, the contacts need to be closed for 12 seconds
to turn the motor from one end-stop to the other end-stop.
To set the valve to the Off position, close contacts 1, 2,
and 3 simultaneously for 1 second.
■
■
■
GENERAL NOTES
An Alex 2510-Z connector (not supplied) must be used to
connect to the receiver. Signal relays (gold contacts) or
opto-couplers are recommended.
Beginning in 2008, receivers produced with the part num-
ber G6R-R3 (or 4) A2… will have the capability of external
source operation.
Figure 1: Wiring diagram and the operation sequence to achieve different
settings
APPLICATION
The GV60 will operate through an external source, such
as a home automation system, by using the 5-wire pin
connector on the receiver.
Mode Contact
High Fire 1
Pilot 3
Ignition 1 and 3
Turn Off 1, 2 and 3
1
2
3
Draft September 16, 2008
APPENDIX B
A p p e n d i x B