Optal 4 Glass 2 burners, Руководство по установке и эксплуатации

Страница: 25 / 166

25
Manufacturer’s Recommendation for Wall Mounting
Stand Alone 40 TS, 75, 75 TS, 110 & 150
1. Concrete Wall
a. Position the unit at the desired height and mark the wall. Unit should have
a minimum 12” and maximum 30” distance from the bottom of the unit to
the floor.
b. Mount the Stand Alone hanging bracket using Hilti 3/8” x 3” Kwik bolt 3
expansion anchors with manufacturer’s requirement of 2-1/2” embedment
and torque to 20ft-lbs.
c. Attach the unit to the mounting bracket.
d. See Sketch 1 for detail.
2. Wood Stud Wall
a. Position the unit at the desired height and mark the wall. Unit should have
a minimum 12” and maximum 30” distance from the bottom of the unit to
the floor
b. Create an opening in the wall big enough to position the 4x8 blocks
between the wood studs at the desired height.
c. Repair the opening with hardy backer board.
d. Make sure that the bracket has a minimum 4” extra hardy backer board
material around it.
e. Mount bracket with a 3/8” x 4” lag bolts. Follow bracket manufacturer’s
installation requirements and then mount the unit.
f. See sketch 2 for detail.
Note: All installations are to be completed per local building codes and safety
requirements. The above recommendation does not take the place of reviewing and
incorporating structural requirements set forth by the building engineer, local codes, etc.