Optal 4 Glass 2 burners, Руководство по установке и эксплуатации

Страница: 72 / 166

72
Handling the Glass
Sketch A
lass Handling G
1. Demonstration
2. Install / Re-Install
a. When installing, install glass base
first and then top.
b. Must use vacuum holder and
secure by using blanket.
c. When closing screw of the glass
trim, close gently with finger
force
(No need to tighten)
until it is closed.
d. When installing the glass back,
make sure that bottom trim
screws are a little bit loose, verify
that the glass is lining on the
bottom trim and not on the screw.
e. Always close bottom glass trim
first (do not tighten yet) and then
top. (Verify that the trim site is at
the right place, levelled and not in
an offset position).
f. When you tighten the screw with
g. Use glass vacuum holder, 10mm key and make sure to secure glass when
it is out of the fireplace.
finger force, you must do it from side to
side (not from the middle to the sides).
h. Please see images on page 73
3. Remove
a. When removing glass, always release top glass trim and then bottom.
b. Use glass vacuum holder, 10mm key and make sure to secure glass when
it is out of the fireplace
c. Please see Sketch A on this page for example of storing glass in a safe
place.
4. Clean
a. Use appropriate material and cleaning agent to clean glass (i.e. soft cloth
and CRL glass cleaner spray for ceramic glass)
Silicon
1. Silicon comes pre-applies to any glass to glass connections, on both sides of the
glass. If silicon is damaged, only then re-apply.
2. See appendix for information on silicon and/or contact ORTAL USA if silicon is
needed.
3. If new silicon is applied, cure time is 24 hours before operation of fireplace
Example of a safe
place to rest glass
panel(s)
Glass
Vacuum glass
holders