Opitec Dragonfly 102.894, Руководство пользователя

Страница: 8 / 35

8
E102894#1
6.1.20 Clean up the outside of the wings (ribs,depron)
6.1.21 The inner end of the wings must be angled. Support one end of the wing with a scrap piece of depron (sk7)
and sand the other end as shown (Sk7)
6.1.22 When finished glue the left and right hand halves of the wing together.
Leave for approx 5 hours to dry. Clean off any excess glue that creeps out of the joint.
6.1.23 Cut out the wing joiner (25 Ext. pack) according to the diagram bend it and glue it in the middle with PVA
white glue. Leave to dry for approx half an hour.
6.1.24 Remove the wings from the board and glue the underneath joiner (24 Ext. pack) with PVA white glue.
6.1.25 Cut out the Dragonfly labels (page 25) and glue them on the wing halves (apply glue around the edges only,
not over the whole area of the paper).
6.1.26 Mount the decor strips (26) on to the wings in your own design and cut off any excess.
100
Use the sanding block against the
edge of the board as a guide
Line up the end of the wing
exactly with the edge of the
board
Wing inner edge
Wing end (outer) supported with a
scrap piece of depron 50mm high
fixed in position with pins
Sk. 7
Sk. 8
Wing joiner upper Wing joiner under
25 24
Dragonfly