SAFETECH ST60-
X
SAFETECH ST60-
X
O p a l e - P a r a c h u t e s . c o m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
[email protected] +33(0)981 144 387
© Copyright 2016 - Opale Aerosystem SARL - Tous droits réservés
O p a l e - P a r a c h u t e s . c o m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
[email protected] +33(0)981 144 387
© Copyright 2016 - Opale Aerosystem SARL - Tous droits réservés
Assembling
Assembling
Attach the line provided to the tube base by passing
the line through the loop.
Take out the other end of the line on the opposit side.
Put the carbon piston on the spring.
Attach the piston on the spring with the 3 plastic
clamps provided.
Tighten them firmly and cut the surplus with a wire
cutter.
Pass the line through the piston.
Prepare 1 CHC M3x8 with a large M3 washer.
Arrange the line loop on the screw, as shown on the
picture.
Insert the screw with the line into the piston middle
hole.
Screw the arming rod. It is also advised to use some
threadlock for this operation.
With the arming tool (sold separately) arm the piston
by pushing down firmly the tube on the tool.
Caution: the pression exercised is important. Take the
necessary precautions.
6
7
