14
Installation Guide
1.
Locate the SCSI cable included with your OnStream Digital Tape Drive.
Figure 12: Attach power and SCSI cables to drive
2.
Connect one end of the SCSI cable to your SCSI controller, aligning the color
stripe on the cable with Pin 1 on the controller connector.
3.
Connect the SCSI cable’s other connector to the SCSI connector on the back
of your OnStream Digital Tape Drive as shown in Figure 12.
Make sure that the SCSI cable’s color stripe is aligned with Pin 1 on your
OnStream Digital Tape Drive as shown in Figure 12.
49
50
1
2
1 2 4 T
5 G G 12
Power
Host interface
Colored stripe
lines up with
pin 1
Pin 1
SCSI cable
Power connector
SCSI connector
Power connector
SCSIInstallGuide.book Page 14 Tuesday, January 19, 1999 1:04 PM