58
Recording
This section explains how to record the input source and
how to record audio and video from separate sources.
Notes:
• The surround sound and DSP listening modes cannot
be recorded.
• Copy-protected DVDs cannot be recorded.
• Sources connected to the analog multichannel input
cannot be recorded.
• Sources connected to a digital input cannot be
recorded. Only analog inputs can be recorded.
• DTS signals will be recorded as noise, so don’t
attempt analog recording of DTS CDs or LDs.
• While the Pure Audio listening mode is selected, the
VCR/DVR OUT V jack don’t output video signal, so
select another mode when recording.
Recording the Input Source
Audio sources can be recorded to a recorder (e.g.,
cassette deck, CDR, MD) connected to the TV/TAPE
OUT jack. Video sources can be recorded to a video
recorder (e.g., VCR, DVR) connected to the VCR/DVR
OUT jacks. See pages 22 to 35 for hookup information.
Note:
If you select a different input source during recording,
that input source will be recorded instead.
Recording from Different AV Sources
You can overdub audio onto your video recordings by
simultaneously recording audio and video from two
separate sources. This is possible because only the audio
source is switched when an audio-only input source,
such as TV/TAPE, TUNER, or CD, is selected, the video
source remains the same.
In the following example, audio from the CD player
connected to the CD IN and video from the camcorder
connected to the AUX INPUT VIDEO jack are recorded
by the VCR connected to the VCR/DVR OUT jacks.
1
Use the input selector buttons to
select the source that you want
to record.
See “Which Connections Should I
Use?” on page 23 to see which signals
can be output and recorded.
You can watch the source while
recording it. The AV receiver’s
MASTER VOLUME control has no
effect on recording.
2
On your recorder, start
recording.
3
On the source component, start
playback.
Remote
controller
1
Prepare the camcorder and CD player for
playback.
2
Prepare the VCR for recording.
3
Press the [AUX] input selector button.
4
Press the [CD] input selector button.
This selects the CD player as the audio source but
leaves the camcorder as the video source.
5
Start recording on the VCR, then start
playback on the camcorder and CD player.
Video from the camcorder and audio from the CD
player are recorded by the VCR.
Camcorder
VCR
CD player
video signal
audio signal
Содержание TX SR507 - AV Receiver
Страница 99: ...99 Memo ...
