17
Before connecting the POWER
• The DV-S939 is shipped with the main power (POWER) switch in the on position ( ON). When the power cord is plugged
in for the first time, the DV-S939 will automatically enter the standby state and the STANDBY indicator will light (same
condition after step 2 below).
• Make sure that all appropriate connections have been completed as described on pages 10 to 13.
• Turning on the DVD Player may cause a momentary power surge, which might interfere with other electrical equipment such as computers. To
prevent interference, use a wall outlet on a different circuit.
Connecting the Power/
Turning on the DVD Player
DISPLAY
OPEN/CLOSE
STOP
PLAY
48/44.1 96/88.2 192/176.4
V I D E O C I R C U I T
O F F
S TA N D B Y / O N
STANDBY
POWER
ON OFF
2
Plug the supplied power
cord into the AC INLET and
then into the power outlet
on the wall.
Notes
• Do not use a power cord other than the one supplied with the
DV-S939. The power cord supplied is designed for use with the
DV-S939 and should not be used with any other device.
• Never have the power cord disconnected from the DV-S939
while the other end is plugged into the wall outlet. Doing so
may cause an electric shock. Always connect by plugging into
the wall outlet last and and disconnect by unplugging from the
wall outlet first.
3
Press POWER to switch on
the main power.
The DVD Player enters standby mode.
The STANDBY indicator lights up.
Notes
• The buttons on the remote controller do not operate if the
POWER switch is set to OFF.
• To switch off the main power, press
POWER
again.
4
Press STANDBY/ON on the DVD Player or
ON on the remote controller.
The DVD Player turns on and the STANDBY indicator turns off.
The first time you turn on the DVD Player, the Initial Setup screen appears.
Press
ENTER
, then follow the procedure on page 54 to set up your DVD Player for the first time.
Notes
• To put the DVD Player in the standby mode, press
STANDBY/ON
on the DVD Player, or
STNBY
(or
ON
) on the remote controller. Be sure to set the volume to minimum before putting the DVD Player in the
standby mode for the next use to avoid sudden loud sound reproduction.
• While the STANDBY indicator lights up, the DVD Player can receive signals from the remote controller.
However, if you press
POWER
on the DVD Player to switch off the main power, the remote controller
cannot be used to turn on the DVD Player.
• You can change the First Setup later with “Customizing the Function Settings” starting from page 44.
• Setting the
STANDBY
button to standby does not shut off the power completely.
AC INLET
To a wall outlet
Power cord
(supplied)
1
For models with a voltage
selector, set VOLTAGE
SELECTOR to the position of
your local power line voltage.
If the preset voltage is not correct for your area, insert a
screwdriver into the groove in the switch. Slide the switch
all the way to the right (120 V) or to the left (220-230 V),
whichever is appropriate.
120 V
VOLTAGE SELECTOR
220 -230 V
