Display Setup
i
i
Serial
Communication
NOTE: There is only one output to operate as a pulse output or an alarm output. Both
cannot operate at the same time.
Serial Communication Settings
If RS485 Communication feature was purchased as the second output for the Model
F-5500, the Serial communication settings can be programmed by pressing
I/O (F1)
key from the Main Menu. The screen will show:
F1 F2 F3 F4
Press
COM (F1)
to select serial communication. The screen may show:
F1 F2 F3 F4
Options for serial communication are:
NONE
MODBUS
BACnet
HART
NOTE: Any selection other than “NONE” requires the communication option for
the selected communication type. If enabling a communication option, see the
Communications Protocols section of this manual.
Display Setup
Remember, there are four display screens that you can cycle through in normal
operating mode (see "Fig. 4.2: F-5500 Measurement Mode Display Screen Navigation"
on page 40). Two of the four display screens are fixed and cannot be changed
(displays #3 & 4). The other two screens are programmable to show the information
that you prefer and is discussed in this section.
Display #1
Display #2
F1 F2 F3 F4
F1 F2 F3 F4
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]
F-5500 Thermal Mass Flow Meter Manual 06/17 - 2030 / 107023
Page 46
Model F-5500
OPERA
TION
DSP1L1
DSP1L2
DSP2L1
DSP2L2
Operation: Programming
SET I/O
COM 420 EXIT
Comm=MODBUS
NXT OK
