Onfloor Propel, Руководство по эксплуатации

Страница: 18 / 90

OPERATION
16
The side brooms move debris from the
edges of the sweeping area into the path
of the main broom.
Check the side brooms daily for damage
or wear. Remove any debris found tangled
on the side brooms or side broom drive hubs.
Check the side brooms daily for proper
adjustment. The right side broom should
contact the floor from a 10 o’clock to
3 o’clock pattern. The left side broom
should contact the floor from a
9 o’clock to 2 o’clock pattern.
For maximum life, the side brooms should
be swapped (from one side to the other)
after every 50 hours of use.
The side brooms should be replaced when
the bristles are too short to sweep effectively
in your application.
ADJUSTING THE SIDE BROOM
The sweeper must be mounted to the
forklift, on the ground, and leveled.
FOR SAFETY: Before leaving the
forklift, stop on a level surface, set
the forklift parking brake, turn off
the forklift and remove the key.
WARNING: Moving belts and pulleys.
Do not attempt to adjust the side broom
when the sweeper is in motion.
1. Loosen the side broom adjustment knob.
2. Raise or lower the side broom to the
correct position. The side broom
assembly can be easily adjusted by
grasping the front of the side broom
gearbox housing with one hand, and
the horizontal plate behind the gearbox
with the other hand. Pull up and
toward the front, or push down
and toward the rear.
3. Tighten the side broom adjustment knob.
It is not necessary to adjust the side broom
drive belt when adjusting the side broom
height.
SIDE BROOMS
,%&43)$%"2//-
6)%7%$&2/-!"/6%
2)'(43)$%"2//-
6)%7%$&2/-!"/6%
3)$%"2//-#/.4!#47)4(4(%&,//2