Onfloor Propel, Руководство по эксплуатации

Страница: 11 / 90

OPERATION
9
1. The forklift forks must be centered
and positioned with approximately a
25mm (1 in.) space between the forks.
2. Position and level the forks so that they
are in line with the inlet of the sweeper
mounting tube.
3. Drive the forklift slowly forward so that
the forks slide easily into the sweeper
mounting tube. If there is any resistance
when sliding the forks into the tube, or
there is a tendency to push the sweeper
out of position, stop the forklift and
reposition the forks so that they slide
easily into the mounting tube.
4. Stop the forward movement of the
forklift when the two vertical plates on
the sweeper mounting tube contact the
fork mounting rack of the forklift.
5. Lower forks until they lay flat on the
bottom of the sweeper mounting tube.
6. Position the horizontal pin into the lowest
hole possible, above the forklift forks as
shown. If the pin does not slide easily
over the forks, use the next higher hole
position. Lock pin in position by inserting
hair spring pins.
ATTACHING THE SWEEPER TO THE FORKLIFT
NOTE: Do not use this sweeper on forklifts
with forks that are more than 1219mm
(48 in.) long.
FOR SAFETY: When not in use, the
sweeper must be stored on a flat, level
surface. The wheels must be chocked to
prevent movement of the sweeper.
NOTE: If the sweeper is being installed on
a different forklift than the forklift previously
used, reposition the horizontal pin into the
highest hole in the mounting tube as shown.
FOR SAFETY: Before leaving the forklift,
stop on a level surface, set the forklift
parking brake, turn off the forklift and
remove the key.