- 8 -
WEEK DURING USE.
Diagram 4
MULTIPLE FLOOR PLAN
Diagram 5
Installation:
Activation
Press test button and hold it for more than 3 seconds
until LED lights, and release it within 2 seconds, the unit
will generate a “beep” indicating that it is activated and
ready to detect status.
CAUTION:
this unit must activated prior to installation.
Failure to perform step will result in a non functioning
smoke alarm!
• Turn the alarm body counterclockwise and take off the
bracket.
• Hold the bracket in the installation position as specified in
the Recommended Locations, mark installation holes of the
bracket with pencil.
• Drill the two marked installation holes with a 3/16 inch
(5mm) drill bit. Tap the two plastic grommets into holes
with hammer.
• Remove locking plug from the bracket with screwdriver if
necessary (Refer to Diagram 6). This is an optional
additional locking in place feature.
• Mount the bracket to the ceiling by inserting and tightening
the supplied screws into plastic grommets. (Refer to
Diagram 7).
• Fit the alarm on the bracket and turn the alarm body
clockwise, until fully inserted on the bracket.
• Optionally insert locking plug into the gap between bracket
and bottom cover for locking alarm in place (Refer to
800.607.054
1
|
31100 Solon Rd STE 16 Solon, OH 44139
