Page 12
For technical questions, please call 1-800-444-3353.
Item 69714
Assembling/Installing the Door
The door is assembled using the Door Screws (44).
The Screws thread directly into the rounded portions of the parts in the center of the door.
1. Place the Left Door Frame (20) with the
Rubber Seal (42) side down.
Attach the Center Door
Frames (26) to the Left
Door Frame (20).
Assemble them with the
rounded portion facing the front,
as shown to the right.
These parts are also marked
with an arrow that needs to point towards
the top of the door.
2. Attach the Right Door Frame (28) to the
Center Door Frames (26) in the same way.
3. Attach the Door Top Frame (24) to the Left and Right
Door Frames (20 and 28).
Turn them so that the rounded
portion faces the front and that
the flange where the pane will sit
faces the center of the door,
see the diagram to the right.
4. Using two Bolts (43) and two Nuts (52), attach
the Door Slider (31) to the Door Top Frame (24)
with the rollers on the top of the door.
5. Attach the Bottom Door
Frame (27) to the Left and Right
Door Frames (20,28) using
two Screws (44) on each side,
as shown to the right.
6. Raise the assembled Door up
and insert the first roller of its
Door Slider (31) onto the Door
Rail (14). Carefully align the
Bottom Door Frame (27) over
the edge of the Front Floor
Plate (17), see illustration to the
right. Carefully slide the door
over and align the other top
Roller as was done earlier.
7. Once the door is installed, install a Bolt (43)
and Nut (52) into the hole on each side of the
Door Rail (14) to prevent the door from sliding
off its rail. Attach the Right and Left Rail End
Caps (49,50) onto the ends of the Door Rail.
Assembling/Installing the Windows
Follow the steps below for each of the two windows.
1. Attach the Side Window Frames (30)
to the Top Window Frame (33),
as shown to the right.
2. Insert Bolts (43) into the
holes at the bottom of the
Side Window Frames (30), so that the threads
stick out the bottom of the window.
3. Remove the protective film from both sides
of the Window Pane (5A). Slide the Window
Pane (5A) into the three sided frame.
4. Slide the Bottom Window Frame (32) onto the two
Bolts (43) and the Window Pane (5A). Secure it in
place with Nuts (52). If needed, apply some pressure
to the heads of the Bolts through the Window
Pane to allow the Nuts to thread on properly.
5. Attach the Window Brace (51) to the Bottom
Window Frame (32) using two Window Screws (45).
The holes on the Window Brace (51)
should face away from the window.
6. Slide the top edge of the Top Window Frame (33) into
the slot at the top of
the Crown (35),
see illustration
to the right.
The window should
be aligned with the
Window Brace (51)
on the bottom.
Slide the window
into place over one
Window Support
Beam (15).
Gradually lower it
into place.
7. Loosen the Nuts (52) holding the
Window Support Beam (15) in place and slide the
Window Support Beam (15) up to touch the window.
Secure it into place.
Rear view
Side view
Crown
(35)
Top Window
Frame (33)
(View from end of Crown.)
SAFETY
FRAME
MAINTENANCE
FOUNDA
TION
Содержание 69714
Страница 1: ......
