3
301 Fulling Mill Road, Suite G ©Copyright 2006 by On-Q/Legrand, Inc All Rights Reserved.
Middletown, PA 17057
www.onqlegrand.com
(800)-321-2343
C. On-Q/Legrand 4 Port Router/Switch Detailed Physical Description
The following information describes the physical characteristics of the On-Q Router/Switch:
1. Router/Switch Module Connection Area
Figure 2
shows the Router/Switch connection area including:
DC Input connector – connection from power supply
WAN (Internet) Port – 8 position RJ-45 jack (connects to Cable or DSL modem)
Local Switch Ports – 8 position RJ-45 jacks (connection from outlets in rooms)
Routing Switch – Disconnects router from 4-port switch when an external router is used.
Reset Button -
A button press (over 3 seconds) resets the Router/Switch unit to the factory
default settings. This clears all user settings, including User Name, Password, IP Address,
and Subnet Mask.
NOTE: Refer to Section IV Configuration for instructions on re-configuring the
Router/Switch.
2. Router/Switch Status LEDs next to each RJ45 connector(see Figure 2)
Power
– On solid green when power is supplied.
Link/Act and 100 Local Port and WAN Port LEDs
Link/Act
– On solid green indicates functional LAN or WAN link through the port with the
attached device. Off means no LAN or WAN connection.
100
– On solid green indicates port is operating at 100 Mbps. Off indicates 10 Mbps.
Figure 2
STATUS
DC Input
Reset
Button
WAN
Port
Local
Switch
Ports
Routing
Switch
