OMS ARIES TG 300C, Руководство по эксплуатации и обслуживанию

Страница: 22 / 32

22
4.4 GENERAL OPERATION CONTROL
Before testing, make sure that the tray is fully locked, then try operation,
proceeding as follows:
1.
press the start button (ON) and the stop button (OFF) (Fig. 11);
2. check that the product holder tray and the product pusher arm move
smoothly;
3. check the operation and adjust the ribbing using the numbered dial;
4. check the operation of the sharpener;
5. check that the product holder tray can only be removed when the
graduated dial is in the “0” position and that after it has been removed, the
dial remains in this position;
6. check whether removing the blade guard rod causes the machine to stop
operating
CHAPTER 5 USING THE MACHINE
5.1
CONTROLS
The controls are located on the
left side of the base.
1. Graduated dial for
adjusting the cutting
thickness.
2. Stop button (OFF).
3. Start button (ON).
Figure 11- Location of the controls