OMS ARIES TG 300C, Руководство по эксплуатации и обслуживанию

Страница: 28 / 32

28
CHAPTER 7 MAINTENANCE
7.1 GENERAL INFORMATION
Before performing any maintenance, it is necessary to:
1. Disconnect the plug from the mains to completely isolate the
machine from the rest of the system.
2. Set the graduated knob that adjusts the ribbing to “0”
7.2 MAINTENANCE
7.2.1 BELT
The belt does not need any adjustment. It must usually be replaced after
3/4 years. For replacement, call the “SERVICE CENTRE”.
7.2.2 FEET
Over time, the feet may deteriorate and lose their elasticity, decreasing the
stability of the machine. It then becomes necessary to replace them.
7.2.3 POWER CABLE
Check the condition of the cable regularly and call the “SERVICE CENTRE”
if it becomes necessary to replace it.
7.2.4 BLADE
Check that the diameter of the blade, after considerable sharpening, is
not reduced by more that 10 mm compared to the original diameter.
To replace it, call the “SERVICE CENTRE”.
7.2.5 WHEELS
Check that the wheels continue to have their abrasive capacity during
sharpening. If this is not the case, they must be replaced to avoid damage
to the blade, therefore it is necessary to call the “SERVICE CENTRE”