Omron WE70-AP, Руководство по эксплуатации

Страница: 73 / 146

4-5
Chapter 4. Advanced Setup
4
Advanced
Setup
192.168.0.1
AP-to-AP Bridging
"802.11a:36CH"
WE70-AP
After Change
Before Change
192.168.0.1
(Factory
shipment
status)
192.168.0.2
LAN
MOD
E
POW
ER
WIRE
LESS
WE7
0-AP FA W
IRE LE
SS LA
N A CC
ES S
PO INT
WE70-AP
LAN
MOD
E
POW
ER
WIRE
LES
S
WE7
0-AP
FA
W IRE
LE SS
LA N
AC CE
SS PO
INT
BSSID: "00-00-0A-68-00-09"
SSID: "omronwe70wlan" (Factory shipment status)
BSSID: "00-00-0A-68-20-01"
SSID: "omronwe70wlan" (Factory shipment status)
AP-2 AP-2 AP-2
AP-1 AP-1 AP-1
[For Reference] Detection of BSSID
Configuring the same SSID (factory shipment status: omronwe70wlan) and channel with a partner
allows detection of partner BSSID.
This makes registration of partner BSSID easier for new registration and switching.
* Enter the desired alphanumeric characters in SSID (within 31 characters) with the attention for capitalization.
* As this configuration of the same SSID is for detection of BSSID only, it does not affect AP-to-AP
bridging for those with a different SSID value.
* To use encryption, the same encryption key must be configured for the wireless units.
* "TKIP", "AES", and "WOC KEY" encryption methods cannot be used at the same time with AP-to-AP bridging.
* To use AP-to-AP bridging with configuration of [WEP (RC4), OCB AES] and [Super AG] as [Yes
(Compressed)], a key index must be configured as same as those that use AP-to-AP bridging.
Communication is unavailable if different key indexes are configured.
Step 1. Configuring IP Address
Change access point AP-2 IP address.
Leave AP-1 as 192.168.0.1.
<To Configure>
(1) Open a setup screen of AP-2 (see Chapter 2-3. Connection check,
Opening Setup Screen (P.2-13)) and click Network settings menu.
(2) Change the IP address to "192.168.0.2".
(3) Click <Apply and restart>.
Click 1.
Click 3.
Enter 2.
AP-2
4-2. AP-to-AP Bridging Setup
This section describes how to configure and verify basic AP-to-AP bridging setup in steps from 1 to 7 below: