Omron WE70-AP, Руководство по эксплуатации

Страница: 12 / 146

10
Precautions for Safe Use
Observe the following precautions when using this product.
1) Dedicated packaging must be used for transportation of this product. Take precautions to prevent
excessive vibration or shock on the product or falling of the product.
2) Storage of this product must be within the specified environment. Allow the product to warm up to room
temperature for at least 3 hours after it has been stored at -10 degrees C or lower.
3) Use the product within the specified temperature and humidity ranges.
4) Do not use the product under the following environments:
• Locations subject to extreme temperature changes resulting in condensation
• Locations subject to static electricity, excessive noise, or electric fields
• Locations where the product may come into contact with water, oil, or chemicals
• Locations where corrosive gases or flammable gases are present
• Locations where large amounts of dust or dirt are present
• Locations subject to spatters, iron chips, or fillings
5) Do not use it outdoors (outside a control panel).
6) Use tape, cord, or other means to hold the product while adjusting the installation position to prevent the
product from damage due to failing.
7) Tighten the mounting screws to the specified torque of 4.4 to 5.3 in lb. (0.5 to 0.6 N m)
8) Provide sufficient space around the product for heat dissipation. Install the products with a margin of
20mm or longer externally.
9) Do not reverse the power supply connection or connect the product to an AC power supply.
10) Use the correct power supply voltage.
11) Use the solid wire, 16 to 12 AWG for power supply. The exposed length of wire is 10 to 11mm(UL
Listing).
12) Do not lay communications cables and antenna cables near other high-voltage cables or power lines.
13) Setup is required after the installation or replacement of this product. Set up the product correctly
according to the manual, and be sure to confirm that communication is established before using it.
14) Do not apply excess vibrations or shock to this product. Do not drop this product.
15) Other wireless devices operating within the same frequency band may interfere with this product or be
adversely affected by this product. Therefore, be sure to perform the test provided with the product (e.g.,
installation tests) before operating it.
16) Make sure that the antenna is not disconnected during operation.
17) Do not use this product near other devices that may malfunction due to the electromagnetic waves
emitted by this product.
18) Turn OFF the power supply before performing any wiring or replacing devices.
19) Do not touch the product with wet hands.
20) Dispose of the product as industrial waste.