![background image](http://html1.mh-extra.com/html/omron/v720-series/v720-series_operation-manual_1633447098.webp)
Communications Methods
Section 5-5
5-40
4)
Polling Auto Mode
If an Auto command is used when a single host controls more than one Controllers, the com-
munications path between the host and one of the Controllers to which the command is sent
becomes busy, disabling the host to control other Controllers. On the other hand, when a Polling
Auto command is sent instead, the Controller returns a response in reply to a Polling subcom-
mand, which allows the host to send a command to other Controllers. During the execution of
the Polling Auto command, commands other than the Polling subcommand, Reset and Stop
commands are not executed. The following flowchart shows the case where the Polling Auto
Command is sent to 2 Controllers.
1)
The host sends the Polling Auto
Command to the Node 1 Controller.
2)
Immediately after command reception,
Node 1 returns a response indicating
the acceptance of the command.
3)
The host sends the Polling Auto
Command to Node 2.
4)
Immediately after command reception,
Node 2 returns a response indicating
acceptance of the command.
5)
The host inquires after the progress of
the communications processing or
stops the Polling Auto processing
using the Polling sub command. When
the communications processing is not
yet complete, the Controller returns a
response indicating unfinished
processing in reply to the inquiry of the
Polling sub command.
6)
The Node 1 communicates with a Tag
entering the communications area.
7)
Node 1 returns a response indicating
the results of communications with the
Tag in reply to the Polling
subcommand.
Tag
Controller
Host
Response
Polling Auto
Command
Node 1
Response
Not approaching yet
Node 2
Node 2
Response
Polling
subcommand
Not approaching yet
Node 1
Node 1
Not approaching yet.
Passing in front of Node
1’s antenna
Referring to Node 1
Response
Not approaching yet
Node 2
Not approaching yet.
Referring to Node 2
Communications
processing
Tag
Response
Communications
processing by Node 1 is
complete.
Referring to Node 1
Polling Auto
Command
Polling
subcommand
Polling
subcommand
Содержание V720 Series
Страница 1: ...Cat No S908 E1 2 ID Controller V720 series Electromagnetic Inductive RFID System 9 OPERATION MANUAL...
Страница 3: ...iv...
Страница 5: ...vi...
Страница 9: ...x...