Omron V400-R1CF, Руководство пользователя

Страница: 34 / 117

33
V400-R1CF/R1CS
User’s Manual
Section
2
Wiring and
Connection
Section 2
Introduction Procedure
„ Settings on the reader
Specify the settings as follows to establish communication with the programmable
controller.
„
Settings on OMRON programmable controller CS1
For information about the detailed setting method, refer to the operation manual of your
programmable controller.
ƒ Program controller system settings - Details
* 0
×
00 means a hexadecimal number, and “0” means a binary number.
Setting item Setting content Command
Communication speed 9600 bps (Factory default setting)
Data length 8 bits (Factory default setting)
Parity None (Factory default setting)
Stop bit 1 bit (Factory default setting)
Header None (Factory default setting)
Footer CR (Factory default setting)
Reading valid time T 2 sec. (Factory default setting)
Process failed reading Transmits “NL” when no label is found
Transmits “ND” when reading has failed TH0N0L
TI0N0D
Setting item Setting content
Dip switch of CPU unit OFF
Program controller system settings 160[830E]
161[0006]
162[0000]
164[000D]
165[0100]
DM setting Set [1B5A] to DM00100
(Memorize “[ESC]Z” of the ASCII code)
160 b15 Presence of the arbitrary
communication setting “1” Arbitrary setting
b11-8 Serial communication mode “11” Nonprocedural
b3 Data length “1” 8 bits
b2 Stop bit “1” 1 bit
b1-0 Parity “01” None
161 b7-0 Communication speed 0
×
06 9600 bps
162 b15-0 Transmission delay time 0
×
0000 No delay
164 b15-8 Start code 0
×
00 None
b7-0 End code 0
×
0D CR
165 b12 Presence of the start code “0” None
b9-8 Presence of the end code “01” The end code is present