Omron SYSMAC C200H-TC, Руководство по эксплуатации

Страница: 17 / 85

6
When various settings require frequent rewriting, write to RAM, verify the setting
values, and then save the data by writing it to EEPROM. The data written to the
RAM will be deleted when the power is turned OFF.
The following commands can be used to write to RAM.
Parameter Command Write Read
Set point 4 0 Yes No
Execution bank number 4 2 Yes No
Alarm SV 1 4 3 Yes No
Alarm SV 2 4 4 Yes No
Input shift value 4 5 Yes No
Proportional band 4 6 Yes No
Integral (reset) time 4 7 Yes No
Derivative (rate) time 4 8 Yes No
SP lower limit 5 0 Yes No
SP upper limit 5 1 Yes No
Control period 5 7 Yes No
Hysteresis 5 8 Yes No
Alarm hysteresis 5 9 Yes No
Heater burnout current 5 B Yes No
Alarm 1 mode 6 4 Yes No
Alarm 2 mode 6 5 Yes No
Basic System Configuration
Section 1-2
Downloaded from Elcodis.com electronic components distributor