Omron SYSDRIVE 3G3SV, Руководство пользователя

Страница: 62 / 64

(0
2-12 Warning and Self-diagnosis Functions
Protection function Explanation Monitor
display
Fault con-
tact output
Low-voltage protection
(main circuit voltage in-
sufficient) Monitor display appears when the main circuit DC
voltage drops under the detection level while the in-
verter output is off. (UV)
(Blink)
Non
operation
Overtorque detection This function is used to protect the machine and to
monitor the inverter’s output torque.
The inverter output reacts in a preset manner when
the inverter output current exceeds the over torque
detection level. The monitor display blinks when “op-
eration continue” is preset. (OL3)
(Blink)
Non
operation
Stall pre-
vention (Ac-
cel/decel is
accom-
plished with
maximum
capacity of
the inverter During ac-
celeration Inverter acceleration is stopped when 170% of or
more of the inverter rated current is required by the
load.
This prevents overload protection (OL2) or overcur-
rent (OC) from occurring.
When current is reduced to less than 170%, acceler-
ation is enabled. --- Non
operation
the inverter
without trip-
ping on
overcurrent
or overvol-
tage.)
During nor-
mal opera-
tion Output frequency is decreased when 160% of the
inverter rated current or greater is required by the
load. This prevents motor and inverter overload
(OL1, OL2). When current is reduced below 160%,
inverter acceleration is then enabled.
During de-
celeration Deceleration is stopped when the DC voltage is
caused to rise by motor regenerative energy.
This prevents overvoltage trips (OV). When DC volt-
age decreases, deceleration to the set value then
resumes.
Simultaneous normal and
reverse rotation com-
mands When forward and reverse rotation commands are
simultaneously detected for a period of time exceed-
ing 500 ms, the inverter is stopped according to the
preset stop method. (EF)
(Blink)
Non
operation
External base block sig-
nal input (main circuit
transistor instantaneous
shut-off) When an external base block signal is input, the mo-
tor coasts to a stop. When the external base block
signal is removed, the inverter output is immediately
turned on at the previously set frequency. (BB)
(Blink)
Non
operation
$
Section 2-12